Description
A AEG 59800 heat pump tumble dryer normally needs about 2.5 to 3 hours to complete a drying cycle. With this fault, the drying time can increase to 6 to 9 hours, without an error message in the display. This problem also occurs in heat pump tumble dryers from the Electrolux EDH series and for example the Zanussi ZTH485. Below you’ll find possible causes and solutions.
The fan on the compressor is controlled via an NTC resistor of 6.7 kOhm at room temperature. The fan must start turning as soon as the compressor gets too hot. Check it like this: open the front door at the condenser, loosen the two Torx 20 screws of the small panel to the right of the door, slide the panel to the left, and remove it.
Also measure on the two wires to the compressor whether there is 230 V on them. If that is the case, the start capacitor, PTC, or the overload protection may be defective. Thorough cleaning is, in many cases, also important.
In almost all cases, however, the electronic module has failed.
We check and repair the module and reprogram it if necessary, so the fault is resolved.
Always unplug the appliance first.
Remove the top cover by loosening the two screws at the rear and sliding the cover backward. Then remove the two, sometimes three, screws that secure the front panel. After that, loosen the two screws behind the water tank cassette; see the photos below. The front panel is now detached.
Remove the module by loosening the Torx 20 screws. Leave the module in the cream-colored holder and send it in.
Questions about this product? Send your question, possibly with photos, to our business WhatsApp 06-25229613 (only messages, you can’t call) or email [email protected]. Euromaxx has more than 30 years of experience in restoring and repairing vintage audio equipment and also repairs white goods electronics and modules.







