Description
With the fault AEG door lock clicks and stops, the washing machine usually just shows lights and seems to be working normally. As soon as you press start, you’ll hear the door lock click a few times. After that, the machine stops, it beeps, and the end light flashes.
If you read a fault code via www.euromaxx.nu/AEG-STORINGSCODES-ZANUSSI-ELECTROLUX-STORINGSCODES, code E31 often appears. This code points to the pressure sensor, but in this case it’s usually not the cause. The problem is often a partially burnt module. Send your module in for servicing.
The order of the troubleshooting steps often stops too early:
1. Replace the door lock.
2. Check whether the water pump is circulating.
3. Check the 3-way water inlet valve.
4. Check the heating element.
5. Check whether the lower circuit board is in good condition.
6. Check whether the motor is a direct drive motor.
7. Replace the water pump.
8. Replace the NTC.
9. Replace the brown height meter.
Also check:
10. Compare the triacs on the upper circuit board and solder the relays again.
Also check the wiring of the black water level controller for the water level and the upper circuit board.




