AEG i30 fault code sensor for dishwasher

Sensor for resolving an i30 water leak fault without an actual leak. Multiple versions are in stock; provide your PNC number for the correct version.

€29.97

Directly available from stock

  • Fast delivery
  • Excellent conditions
  • Very high satisfaction
  • Professional staff
SKU: BB7-A Category:

Description

If the AEG i30 fault code or error code 30 appears on the display of an AEG, Zanussi or Electrolux dishwasher, this indicates a water leak fault.

Do not order this item just like that; read the information below carefully first.

There are two possible causes: there is an actual water leak, or there is no leak but an electronic fault.

1. THERE IS A REAL WATER LEAK;

First check whether there is indeed a water leak or whether it is an electronic fault. On the front side, at the bottom of the machine, there is a metal plinth. This can be removed without having to build out the dishwasher. The plinth is usually secured with 2 or 4 Torx 15 or Torx 20 screws. After that, you can look at the base plate inside the appliance.
With a flashlight you can see whether there is water on the base plate. If so, there is a real water leak. Then continue reading in the article about AEG i30 fault due to leaking.

2. THERE IS NO WATER LEAK;

In that case, the sensor, see photo, is usually defective. The sensor then gives an incorrect signal. For safety, the dishwasher will start draining. Therefore, replace this sensor.
The sensor is located in the sump. Replacement is easy: remove the lower metal cover or cover panel at the front under the door. The sensor is then immediately visible. It has small clips and often needs to be turned a quarter turn. So you do not need to take the appliance apart.
There are multiple models and versions available, as shown in the different photos. Everything is in stock.
Write the PNC number in the end of your order, in the COMMENTS box. This number is usually on the right side of the door on a sticker. That way we ensure you receive the correct version. If you do not provide a number, we will ship the most commonly supplied version.

In a very exceptional case, after replacement the dishwasher may show a fault code again. With a persistent fault in the fault module, you can pull the plug from the outlet, disconnect the plug from the heating element, and restart the dishwasher. Wait 3 minutes. As soon as the machine starts taking in water again, you can reconnect everything.

FURTHER

Almost all items may be returned to us, but this item can only be returned if the sealed packaging is unopened and undamaged. In the past, this item was used to test machines, during which the sensor was sometimes damaged.

If the fault has not disappeared after the repair, in exceptional cases the height adjustment may also be defective. Read more about the AEG dishwasher pressure switch . Some customers order this directly as well to be completely sure. 000140000401061 30162020001

Exception: sometimes there really is water on the base plate. If you dry the bottom and start the dishwasher, then water can come out of the two small disconnected hose sections. These hose sections exit the base plate without any connection fitting attached. They are the two overflow hoses from the door. In that case, the dishwasher takes in too much water because the level sensor is defective. As a result, the machine drains the water. Then it is indeed a real leak, but the cause is as described above.