AEG Zanussi Electrolux dishwasher pressure sensor fault i40 i43 i44

Replacement pressure sensor for fixing the i40, i43 and i44 water level fault in AEG, Zanussi and Electrolux dishwashers. Prevents the machine from beeping or flashing 4 times and refusing to start. Available directly from stock. Please include your machine number in the notes field when ordering for a guaranteed correct match!

€29.79

Directly available from stock

  • Fast delivery
  • Excellent conditions
  • Very high satisfaction
  • Professional staff

Description

Is your dishwasher showing an i40, i43 or i44 error code, or does the appliance beep/flash 4 times? This points to a problem with the pressure sensor or water level control. The machine no longer measures the exact water level correctly, so for safety the program refuses to start.
Cleaning the old sensor with vinegar, bleach or drain cleaner unfortunately does not help, or hardly at all, in practice. Dirt and soap residue build up deep inside the part where cleaning agents cannot reach. Replacing it is the only permanent and reliable solution to get your dishwasher working again quickly.
Important product features:
    • Troubleshooting: Directly fixes the i40, i43 and i44 faults where the dishwasher refuses to start or signals 4 times in a row.
    • Suitable for brands: Original replacement part for dishwashers from AEG, Zanussi and Electrolux.
    • Check your model: When completing your order, enter your machine numbers (PNC code or model number) in the NOTES field. These can be found on the sticker on the side of the dishwasher door. We will check free of charge whether you receive the correct version.
    • Easy installation: The dishwasher does not need to be removed for this repair. The sensor is directly accessible via the plinth at the front of the machine.

Step-by-step guide for self-installation:
    1. Disconnect the appliance from the power and remove any remaining water from the tub and pump sump with a dry cloth.
    2. Remove the wooden kitchen plinth and unscrew the metal plinth (approx. 15 cm high) on the underside of the dishwasher with a Torx screwdriver.
    3. Locate the pressure sensor on the underside of the sump (see the position marker in the product photos).
    4. Carefully push the plastic locking tab on the bottom slightly down and disconnect the old sensor.
    5. Clean the opening under the filter thoroughly and install the new pressure sensor.
    6. Note during installation: If the new rubber ring does not seal precisely right away in the rare case of a batch, simply transfer the rubber ring from your old sensor.

Need help or advice?
Have questions about the fault code or installation? Send a message with photos to our business WhatsApp via +31625229613 (Please note: this number can only receive WhatsApp messages, calling is not possible). You can also send an email to [email protected].
Return conditions:
  • This delicate electronic repair part can only be returned unopened, unused, and in its original, undamaged packaging.
  • Parts that have already been installed, connected, or tested are excluded from the right of return.

You may also like…