Description
When a Bosch Siemens dishwasher gets stuck at 1 minute, it is important to pay close attention to the symptoms. There are two variants, both of which can cause the program to remain stuck at 1 minute before the end time.
A characteristic of the first variant is that everything seems to work normally until 1 minute before the end time. The dishwasher may then sometimes hum softly and then gets stuck. The fill valve can get stuck on the second cycle, but usually the cause lies with the level chamber or the labyrinth. Also see this topic www.euromaxx.nu/products/bosch-siemens-neff-atag-niveaukamer/
The second variant occurs only in models where the circuit board is located at the top of the door. If you have a model with a large white cassette at the bottom right against the side, you can rule out this second possibility.
If the circuit board is indeed at the top of the door, then we continue with the second variant. The fault has the same symptoms as the first variant, but there were often earlier complaints that the dishwasher does not dry properly . First check everything described for the first variant, because the level chamber is often the cause. If nothing can be seen there, there is a good chance that the module is defective. You can send it in for repair or overhaul and order this overhaul for € 59.95.
Unplug it from the socket.
The circuit board is located at the top of the door. To do this, loosen a number of Torx 20 screws, not from the entire board but only from the upper section. Note: there is also one screw on both sides that needs to be loosened.
The module is located directly under the buttons.
During disassembly, take good photos of all wires and connections.
You can order the overhaul of your circuit board by using the green button Add to cart .
Then send the cassette with the module inside







