Description
Problem: Electrolux beeps 4x, error i40/i43/i44
When your Electrolux beeps 4x, this can indicate different causes. For error code i40, i43 or i44, the fault usually has to do with the pressure sensor or the water level control.
- The Electrolux dishwasher shows error code i40, i43 or i44.
- The Electrolux dishwasher beeps or flashes 4 times.
- The dishwasher does not start.
Solution: Electrolux fault i40/i43/i44, beeps/flashes 4x
Error code i40, i43 and i44 indicates a fault in the pressure sensor and the water level control.
If this code appears on an AEG, Zanussi or Electrolux dishwasher, the water level is not measured correctly. Most of the time, the sensor is defective and must be replaced.
This is usually not a major repair. Below you can read how to tackle it. The sensor is located at the bottom, in the pump sump.
Order the pressure sensor and at the end of your order, under COMMENTS, enter the machine numbers. These are on a sticker on the side of the door.
We make sure you receive the correct sensor, because multiple versions are possible.
Further explanation:
The sensor often fails due to dirt and soap residue buildup on the inside.
Sometimes it is advised to clean the sensor with cleaning fluid, chlorine, vinegar or even a drain unblocker, or only clean the filters. This rarely helps or helps at all. You cannot reach the inside of the sensor properly, even with water and cleaning agent. That is why replacement is usually the right solution.
Note: in a small series of exceptions, the rubber from the new sensor does not fit properly. You can see this immediately during installation. In that case, transfer the rubber ring from the old sensor; see the photo with the small rubber piece.
What should you do?
Most of the time it is an integrated dishwasher and you do not need to remove it.
Remove the metal plinth at the bottom of the front of the appliance. On the floor, there is often first a wooden toe-kick/cover panel for the kitchen. Remove it, and then you will see the dishwasher’s metal plinth. It is about as wide as the dishwasher, roughly 15 cm high, and usually secured with 4 torx screws.
On the photo you can see approximately where the sensor is located.
You can pull this part out by pushing the tab slightly downward on the underside. First remove the water from the tub. Use cloths to suction out the remaining water from the pump sump and also collect as much residual water as possible at the bottom using cloths.
If on the inside, under the strainer, there is a direct hole to the sensor, clean that as well.
Want to see how it should be done? Watch the video.
Note: some customers think the sensor is the small eye at the front of the pump sump. That is not the case. See the circle in the photo for the position where the sensor is usually located.
In an exceptional case, the fault remains after replacement. Then fill the pump sump with a splash of chlorine and hot water and leave it overnight. If the fault is still not fixed after that, the circuit board may have been damaged by the defective sensor.
#140000554083 #dishwasher fault aeg
Also check out other AEG faults: AEG faults






