Description
INDESIT ERROR CODES WASHING MACHINE
| With these Indesit error codes for the washing machine, you can recognize the error message from, among others, the Indesit W123. In case of a fault, the program dial turns. The number of times the start LED flashes after the fast flashing indicates the fault code.
F01 Short circuit in the triac. F02 Motor standstill (tacho or carbon brushes). See also F06. F04 Water level too high. F05 Fault in the pump or the filter. F06 Program error or fault in the motor control. This can also be the door lock, sometimes in combination with F02 messages. Sometimes only draining works, and then the door locks too, but spinning and other program parts no longer work. The door lock light then stays on. Read more about Indesit F06 error. F07 Heating problem (relay). Possible causes: a loose wire on the heating element, a defective heating element (measure the resistance; it should be about 30 ohm) or a defective module. F08 Fault in the heating or water level sensing. F09 EEPROM fault in the module. F10 Water level controller does not work properly. F11 Pump or drain pump motor defective. F12 Communication fault. Codes with indicator lights The indicator lights are numbered from left to right from 1 to 4. F01: indicator light 4, motor triac. F02: indicator light 3, motor blocked/tacho. F03: indicator lights 3 & 4, NTC fault. F04: indicator light 2, pressure switch remains at empty. F05: indicator lights 2 & 4, pressure switch remains at full. F06: indicator lights 2 & 3, n/a? F07: indicator lights 2 & 3 & 4, heating relay. F08: indicator light 1, heating relay. F09: indicator lights 1 & 4, EEPROM/setting fault. F10: indicator lights 1 & 3, pressure switch does not detect. F11: indicator lights 1 & 3 & 4, pump/drain error. F12: indicator lights 1 & 2, communication error. F13: indicator lights 1 & 2 & 4, dryer NTC/ventilation motor. F14: indicator lights 1 & 2 & 3, dryer heating. F15: indicator lights 1 & 2 & 3 & 4, relay for dryer heating. F16: n/a. F17: indicator light 4, door lock. F18: indicator light 3, communication error (3-phase motor) on the circuit board. F01 and F17 use the same indicator light. SHORT CIRCUIT If the washing machine, in this case an Indesit WIDL146 S/N 506038022 80305730900, causes a short circuit while spinning, the main switch may turn off. After turning it back on, the machine continues until it needs to spin again. Most of the time, the carbon brushes are the cause. Often there were already signs earlier that spinning was getting difficult. Then replace the carbon brushes. When this fault is allowed to persist for too long, the motor can also become defective. Then email for another used motor, because a new one costs around 250.00. Buttons that stick can sometimes occur. Detach the small cover above the buttons and apply a small amount of grease to the silver-colored spring. Note: this spring can jump off. DRAIN IMMEDIATELY: sometimes in combination with flashing indicator lights 3 and 4 and a fast-flashing door lock light. The pressure switch then receives the signal that too much water is entering the machine and lets the machine drain directly after the water intake. Sometimes you can see in the drum that the water level really does rise too high. The pressure switch may be defective. The small hose to the tub may also be clogged, causing the pressure switch to pass on the wrong value. Carefully blow through this hose. |




