Miele condensdroger aardlek springt eruit

Step-by-step plan for when a Miele condenser tumble dryer trips the RCD. First check overloading, heating element, condenser and RT fan.

€0.00

Directly available from stock

  • Fast delivery
  • Excellent conditions
  • Very high satisfaction
  • Professional staff
SKU: AD125 Category:

Description

When a Miele condenser tumble dryer RCD trips, it’s important to first determine exactly what is switching off: the RCD or the circuit breaker. Most of the time it’s the RCD, but always start by checking the circuit breaker.

If the porcelain fuse in the distribution board switches off, this indicates a short circuit or overloading. Carefully feel whether the relevant fuse is warm or hot. If it is, then this circuit is probably overloaded in combination with the tumble dryer, which at certain times can consume up to 2800 watts. Switch off all other appliances on this circuit and try again. If the fuse is not warm and there’s no sign of overloading, follow the steps below for an RCD fault. The RCD is the switch in the distribution board that you move up or turn a quarter turn.

1. First try running the dryer without any laundry for 15 minutes on cold, or on a program where it doesn’t heat. If the machine keeps turning in both directions in that case, then the heating element is suspicious. Damp dust can also cause a short circuit. In that case, loosen the screws on the back of the housing, clean everything thoroughly, and check the heating element and the clixons. For this, see the topic Miele heating element tumble dryer. Note: this is not a straightforward job. Also clean the channel from the element to the grille using an angled brush or bokkenpoot and a vacuum cleaner.

Or

The condenser is clogged. It may look clean, but it can still be severely contaminated. While it is heating, feel in the lower left area, so underneath the condenser, to see whether there is a blast of stuffy, damp and very hot air there. Normally, you should feel slightly warm air being drawn in there instead. If the air is hot and damp, the condenser is likely severely clogged. Flush it out with high-pressure spray and try again. Not sure? Do a load in the dryer, turn everything on and let it run with the condenser cover open and the cassette removed. If the dryer then keeps running until the laundry is dry, the cause lies with the condenser.

Finally

If the RCD keeps switching off despite all the cleaning work, the RT fan must be replaced. The photos below are intended for an air-vented tumble dryer.

For a condenser tumble dryer you remove the bottom panel. That’s where you can already see the loose fan.