Miele wrinkle guard/end light comes on

Does the Miele wrinkle guard/end light come on and stop the program early? Read which checks and parts are relevant for this fault.

€59.95

Directly available from stock

  • Fast delivery
  • Excellent conditions
  • Very high satisfaction
  • Professional staff
SKU: AD021002 Category:

Description

Does the Miele wrinkle guard/end light comes on and stop your washing machine during the program? Below is an example of this fault on a Miele V4725 NR00/49748593 with an EDPL 102B module.

When you start it, everything initially seems fine: the machine takes in water, but only through the rear compartment of the detergent drawer (pre-wash), and it turns a few times. The time starts out as normal at 1.32 hours.

After about 3 minutes, the remaining time suddenly jumps to 0.54 hours. The machine drains, the soak/pre-wash light briefly flashes twice, then the end light comes on and three horizontal dashes appear.

On the 95 °C whites/coloureds program, everything seems to go fine at first, but the machine skips the water intake. After about 1 minute it goes into a fault condition: the soak/pre-wash light flashes twice quickly and immediately afterwards the wrinkle guard/end light comes on. No water enters then.

On the rinse/cold recovery program at 50 °C, the machine does take in water, but only through the rear compartment of the detergent drawer and in small amounts. The drum turns a few times, and then after about 3 minutes the same fault occurs again.

On the rinse program, the machine does take in enough water and the program works normally.
Also spinning (8 minutes) works properly.

This fault is often caused by the electronics in the detergent drawer, but the circuit board can also be defective. For more information, see the Miele circuit board module EDPL102-A / EDPL102A.