Whirlpool Bauknecht washer error F08

Explanation and measuring instructions for error F08 on Whirlpool and Bauknecht washing machines. Check the heating element, NTC, wiring and electronics before ordering parts.

€59.99

Directly available from stock

  • Fast delivery
  • Excellent conditions
  • Very high satisfaction
  • Professional staff
SKU: DS02758291 Category:

Description

The Whirlpool Bauknecht F08 error indicates a problem with the heating. The cause may lie with the heating element, the NTC temperature sensor, the wiring or, in some cases, the drain. Also check for a jammed eco-ball in the hose between the drum and the pump, coins or a blockage caused by wipes. Always unplug the machine from the mains first.
1. Remove the back panel and test the heating element.

Measure about 25 ohms between the terminal where the brown wire is connected and the terminal where the blue wire is connected. First remove the wires from the element before measuring. Also measure both terminals separately relative to earth: the nut where the green-yellow wire is connected. This measurement must be infinite; so you should not measure any resistance.
The element is checked when the washing machine is switched on. If the measured value is not correct, error F08 appears. For a suitable element, also see www.euromaxx.nu/products/whirlpool-verwarmingselement-l265xb65xh18/ If you order this item, you will receive a new heating element. When completing your order, enter the service number or type number of your machine in the REMARKS field. This is located in the door opening. Then we will send the correct heating element. Without this information, we will send the most commonly supplied element.
If these values are correct, follow the two wires from the element to the electronic module and measure the resistance there again. This checks for an interruption or cable break. The element is checked when the machine is switched on and if the value is not correct, you will get F08. When you order this item, you will receive a new heating element without NTC.

2. Measure the NTC. You should measure a value of about 20 kOhm and it must not be interrupted.
The photo below shows the NTC. In the photo above, this is the connector with the two red wires.

If no abnormalities are found, F08 can also be caused by:
3. faulty software in the electronic module. Send the module in for servicing. Read more at www.euromaxx.nu/products/whirlpool-printplaat-module-platine/ Please note: after servicing, reset the machine first. Hold the reset button a little longer until RES appears on the display, if your machine has one. Then restart the machine.
NB: if this error appears after a servicing of a circuit board, send the circuit board in again. We will read it out and investigate where the fault comes from. In many cases, it turns out that the heating element expands when it heats up and causes a short-circuit fault, which damages the module. The module is then repaired again, but first replace the element before putting the module back. We can send this element along with the repaired circuit board.
Finally, there can also be a fault in the pressure switch. This is rare, but not impossible. Also read http://www.euromaxx.nu/WHIRLPOOL-BAUKNECHT-NIVEAUREGELAAR-PRESSOSTAAT